Nutone TWO-NOTE WIRELESS CHIME LA-205WH Manuel d'utilisateur télécharger pdf

INSTALLATION & OPERATING INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

Two-Note Wireless Chime

MODEL: LA-205WH

FIGURE 2

COVER

FIGURE 3

MOUNTING THE PUSHBUTTON

TRANSMITTER

Refer to Figures 1 and 2.

1. Locate the Transmitter next to or near the door. Do not mount the

ransmitter on a metal surface. Caution: Some stucco houses

have metal mesh in the wall structure which will affect the

wireless chime performance. Experiment with various positions

of receiver with respect to the pushbutton to determine the

location that gives best performance before mounting

permanently. If not satisfied, use a wired chime.

2. Remove the Transmitter cover by inserting the tip of a screwdriver in

the slot at the bottom of the Transmitter and then gently rock the

Transmitter cover apart from the Transmitter base.

3. Choose a level place to locate the Transmitter base.

4. Position the Transmitter base, and mark the mounting surface with a

pencil through the two holes in the Transmitter.

5. Drill two

⁄16” diameter holes at the previously marked area.

6. Insert the plastic anchors into the

⁄16” diameter holes.

7. Place Transmitter base over anchors, and fasten with two screws

provided. Do not replace cover at this time.

8. Apply a small amount of caulking to the mounting screw holes on the

base for waterproofing.

TRANSMITTER SECURITY CODING

Refer to Figure 3.

It is not necessary to change the security code of the Transmitter

unless you experience interference from other wireless devices.

1. To change the security code, remove any combination of the six plastic

jumper straps.

NOTE: Both the Transmitter and Receiver codes must match.

BATTERY INSTALLATION

efer to Figure 3.

1. Position the A23 12 volt battery

as illustrated. Be sure to observe polarity (+/–). For replacement

battery, use EverReady

A23BP or Duracell

MN21B (or equivalent).

INSTALLING TRANSMITTER COVER

Position the Transmitter cover over the Transmitter base so that the

“lip” on the base engages into the “slot” on the cover. Make sure the

rubber gasket is properly seated. Firmly press cover until it snap fits

over the base.

SLOT

DO NOT MOUNT ON

METAL SURFACE

LIP

MOUNTING

SCREWS

WATERPROOF

GASKET

BASE

WOODEN WALL OR

DOOR FRAME

PLASTIC

WALL

ANCHORS

TOP

P.C. BOARD

BATTERY

LOCATION

SECURITY CODE

SETTING

FIGURE 1

TO OPEN

COVER “PUSH”

SLOT

1 2 3 4

Résumé du contenu

Page 1 - Two-Note Wireless Chime

INSTALLATION & OPERATING INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!Two-Note Wireless ChimeMODEL: LA-205WHFIGURE 2COVERFIGURE 3MOUNTING THE PU

Page 2 - PREPARING THE RECEIVER

REMOVING THE RECEIVER COVERRefer to Figure 4.1. Press the center of the battery cover, and slide cover toward bottom ofreceiver.2. Set battery cover a

Page 3 - Carillon sans fil à

INSTRUCTIONS D’INSTALLATION LIRE ET CONSERVER CES INSTRUCTIONS!Carillon sans fil à deux tonalitésMODELE: LA-205WHINSTALLATION DU BOUTON-POUSSOIR/TRANS

Page 4 - GUIDE DE DÉPANNAGE

PREPARATION DU RÉCEPTEURProduct specifications subject to change without notice.Les spécifications de cet article peuvent changer sans préavis.4820 Re

Commentaires sur ces manuels

Pas de commentaire

Nutone TWO-NOTE WIRELESS CHIME LA-205WH Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Meubles Nutone TWO-NOTE WIRELESS CHIME LA-205WH. NuTone TWO-NOTE WIRELESS CHIME LA-205WH Manuel d'utilisation Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Meubles Nutone TWO-NOTE WIRELESS CHIME LA-205WH