NuTone NS5430SS Manuel d'utilisation et d'entretien télécharger pdf (Page 5)

NS54000 SERIES

Page 5

INSTALL UPPER FLUE MOUNTING

BRACKET

1. If a framing member is not present, drill two

⁄16” diameter

holes where shown. Insert drywall anchors into the holes.

2. Center the bracket over the hood location and flush with the

ceiling. Make sure that the slots of the upper flue bracket are

at the bottom. Secure the upper flue bracket to the wall using

(2) #8 x 1½” mounting screws.

3. Tighten the screws completely. Make sure that the bracket

is tight against the wall.

Flush with

the ceiling

Center of

installation

Upper flue mounting

bracket slots

5¾”

⁄8”

Recommended

distance between

screw holes

Ceiling

Ø 5/16” TYP.

Ceiling

Center of installation

INSTALL THE HOOD

(Horizontally Ducted Hoods Only)

1. DO NOT REMOVE the protective plastic film covering the

decorative flues at this time.

2. Lay the back side of the hood flat on a table. Use a piece of

cardboard to avoid damaging the table or the hood.

3. Attach damper / duct connector to top of hood using (4)

#8 x 3/8” Pan Head mounting screws.

4. Remove the grease filter by pulling down the metal latch tab

and tilting filter downward to remove.

5. Carefully rotate hood upright.

HOLE LOCATIONS

Ø5/16” TYP.

MOTOR/BLOWER

ASSEMBLY

SIDE VIEW

INSIDE BACK

OF THE HOOD

6. Make sure there will be adequate clearance between top of

hood and lower flue mounting bracket for ductwork. Elbow

must be located below lower flue mounting bracket.

7. Align the hood and center it above the hood mounting

bracket. Gently lower the hood until it securely engages the

bracket.

8¼”

MAX.

LOWER FLUE

MOUNTING BRACKET

8. If a framing member is not present: With the hood hanging

in place, drill through both holes located in the inside lower

back of hood using a 5/16” drill bit. Insert the included drywall

anchors into the drilled holes (one for each hole).

9. Install (2) washers and (2) #8 x 1½” mounting screws through

the back of the hood and into the drywall anchors. Verify

that the hood is centered and leveled. Tighten all screws

completely.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

NuTone NS5430SS Manuel d'utilisation et d'entretien Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine NuTone NS5430SS