NuTone 745BNNT Manuel d'utilisation et d'entretien télécharger pdf

Page 1

MODEL 745BNNT

DECORATIVE VENTILATION

FAN WITH LIGHT

READ AND SAVE THESE INSTRUCTIONS

TYPICAL INSTALLATIONS

HOUSING

MOUNTING TABS

POWER CABLE

GRILLE

PAN

GLASS

LIGHT SHADE

CEILING

JOIST

CEILING

MATERIAL

HOUSING

HOUSING MOUNTED

DIRECTLY TO JOIST

2x6 (or larger)

Discharge parallel to joists.

HOUSING

2 x 4

CEILING

JOIST or

TRUSS

MOUNTING

TABS

POWER CABLE

ADDITIONAL

FRAMING

2 x 4

CEILING

JOIST or

TRUSS

GRILLE

PAN

GLASS

LIGHT SHADE

CEILING

MATERIAL

HOUSING MOUNTED

TO 2x4 TRUSS

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

HOUSING

MOUNTING

TABS

POWER CABLE

ADDITIONAL

FRAMING

JOIST

GRILLE

PAN

GLASS LIGHT SHADE

CEILING

MATERIAL

HOUSING MOUNTED TO “I” JOIST

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

Additional framing must be a 2x6 (minimum height), at least 9-inches long.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufac-

turer. If you have questions, contact the manufacturer at

the address or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at

service panel and lock the service disconnecting means

to prevent power from being switched on accidentally.

When the service disconnecting means cannot be locked,

securely fasten a prominent warning device, such as a

tag, to the service panel.

3. Installation work and electrical wiring must be done by

a qualified person(s) in accordance with all applicable

codes and standards, including fire-rated construction

codes and standards.

4. Sufficient air is needed for proper combustion and

exhausting of gases through the flue (chimney) of fuel

burning equipment to prevent backdrafting. Follow the

heating equipment manufacturer’s guideline and safety

standards such as those published by the National Fire

Protection Association (NFPA), and the American Society

for Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not dam-

age electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. DO NOT install in a tub or shower enclosure.

8. This unit must be grounded.

9. This unit

is U.L. listed. Type I.C. inherently protected.

CAUTION

1. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

2. This product is designed for installation in FLAT CEILINGS

ONLY. Do not mount this product in a wall.

3. The light fixture assembly must be mounted to the fan

housing assembly included with this product. Do not

mount the light fixture assembly to a wiring outlet box.

4. To avoid motor bearing damage and noisy and/or unbal-

anced impellers, keep drywall spray, construction dust,

etc. off power unit.

5. Please read specification label on product for further

information and requirements.

Installer:

Leave this manual with the

homeowner.

Homeowner:

Use and Care information on page 4.

PLAN THE INSTALLATION

SUSPENDED CEILINGS

Housing hung with wires -

3-point mount.

MOUNTING

TAB

GRILLE

PAN

SUSPENDED

CEILING

MATERIAL

POWER

CABLE

4" ROUND

DUCT

HOUSING

GLASS

LIGHT SHADE

ROOF CAP*

(with built-in

damper)

WALL CAP*

(with built-in

damper)

4-IN. ROUND

ELBOWS*

4-IN. ROUND

DUCT*

FAN

HOUSING

Seal gaps

around

housing.

Seal duct

joints with

tape.

Keep duct

runs short.

INSULATION

(Place around and

over fan housing.)

POWER

CABLE*

*Purchase

separately.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - FAN WITH LIGHT

Page 1MODEL 745BNNT DECORATIVE VENTILATION FAN WITH LIGHTREAD AND SAVE THESE INSTRUCTIONSTYPICAL INSTALLATIONSHOUSINGMOUNTING TABSPOWER CABLEGRILLEPA

Page 2 - INSTALL THE HOUSING

Page 2MODEL 745BNNT 3. Set housing aside and drive nails partially into joist at the top of both key-hole marks.4. Hang housing from nails and pound

Page 3 - GLASS SHADE

Page 3MODEL 745BNNT BLKVENTSWITCHBLUBLKWHTWHTWHTLIGHT(WHITE)GRDVENT(BLACK)UNITSWITCH BOXLIGHTSWITCHLINEINBLKREDWHTGRDSCHEMATIC WIRING DIAGRAMSWITCH B

Page 4 - WARRANTY

Page 4MODEL 745BNNT USE AND CARE USE AND CAREWARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND LOCK OUT SERVICE PANEL BEFORE CLEANING OR SERVICING THIS

Page 5 - PRECAUCIÓN

Página 5MODELO 745BNNT VENTILADOR DECORATIVA CON LA LUZLEA Y CONSERVE ESTAS INSTRUCCIONESINSTALACIONES TÍPICASCUBIERTA MONTADA DIRECTAMENTE EN LA VIG

Page 6 - INSTALACIÓN DE LA CUBIERTA

Página 6MODELO 745BNNT 3. Coloque la cubierta a un lado e introduzca parcialmente los clavos en la vigueta, en la parte superior de ambas marcas de

Page 7 - MODELO 745BNNT

Página 7MODELO 745BNNT INSTALACIÓN DEL SISTEMA DE CONDUCTOSAL RASNOTA: El conector del conducto tiene una aleta compensadora para el regulador de ti

Page 8 - GARANTIA

Página 8MODELO 745BNNT USO Y CUIDADOADVERTENCIA: DESCONECTE LA CORRIENTE ELECTRICA Y BLOQUEE EL TABLERO DE SERVICIO ANTES DE LIMPIAR OR REPARAR LA UN

Commentaires sur ces manuels

Pas de commentaire

NuTone 745BNNT Manuel d'utilisation et d'entretien

Naviguer en ligne ou télécharger Manuel d'utilisation et d'entretien pour Ventilateurs des ménages NuTone 745BNNT. NuTone 745BNNT Use and Care Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages NuTone 745BNNT