NuTone VX550 Guide d'installation télécharger pdf (Page 10)

CI390 & CI395

ELECTRAVALVE

™

ELECTRIFIED

INLET INSTALLATION

(CI395RK ROUGH-IN)

1. See Figure 27. Fasten the mounting plate to a stud

within three studs (48") of an electrical outlet box.

Measure and mark the wire 10" from the plug (A). Feed

the wire through the top hole in the mounting plate (just

above the circular opening). Snap the molded plug into

the mounting plate as pictured (B). This will keep it secure

and out of harm’s way during drywalling and finishing.

Line up the wire at the previously measured 10" mark with

the strain of relief channel on the back of the mounting

plate. Secure it in place with the supplied wire tie (C).

2. Run the inlet wire to the adjacent electric box. If you must

run wire through a stud, drill directly through the center

of the stud (D).

3. See Figure 28. Place the exposed ends of the two wires

into the electrical box through a strain relief channel (E).

Tighten the strain relief channel (do not overtighten) on

the white sheathing leaving 1⁄2" of this sheathing

exposed inside of the outlet box.

Fold the 6" of black and white wire into the outlet box. Leave

the wires to be connected by the electrician when plug

receptacles are being installed. (Attention: Power tools such

as routers are not recommended for use with the inlet

installation, as removal of drywall with these devices may

cause damage to the mounting plate and/or inlet plug).

4. Once drywall and finishing processes have been

completed, remove molded plug from mounting plate

(with the aid of a slot screwdriver) and snap it into the

wing slot at the back of the inlet (F). (NOTE: molded plug

fits one way only, with the narrow opening at the top).

Insert inlet into the mounting plate and secure inlet to

mounting plate with screws provided.

NOTE: All electrical devices such as the electrified inlet

should be reported to the construction electrician for

listing on the inspection report for building inspection

purposes.

NOTE: Plumb inlet to tubing using NuTone Model CF382S

90° ELL fitting.

AE0038

AE0039

WARNING

All location and installation direct connect

electrified wall valves must conform with all local

and municipal building codes.

FIGURE 27

FIGURE 28

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

NuTone VX550 Guide d'installation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs NuTone VX550