NuTone NS5430SS Manuel d'utilisation et d'entretien Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
NS54000 SERIES
Page 3
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
MEASURE THE INSTALLATION
The minimum hood distance above cooktop MUST NOT BE
LESS than 24”.
A maximum of 30” above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 30” are at the installer and users discretion;
providing that the ceiling height permits.
CONTENTS
6”
ROUND DUCT
ROOF
CAP
ROUND
ELBOW
24” TO 30” ABOVE
COOKING
SURFACE
WALL
CAP
HOOD
DECORATIVE
FLUE
HOOD
12
3
/4TO CENTER
OF
HOOD MOUNTING
BRACKET
HOLES
ROUND
ELBOW
HOOD
MOUNTING
BRACKET
24” TO 30” ABOVE
COOKING
SURFACE
DECORATIVE
FLUE
6” ROUND DUCT
ROOF
CAP
WALL CAP
8 FT. - 9 FT. CEILING
3
3
/8
DUCT
CENTER
LINE
NON-DUCT
PLENUM
2 TIE
WRAPS
FLEXIBLE DUCT
NON-DUCTED
RECIRCULATION
FILTER
NON-DUCT PLENUM
COLLAR
8 MOUNTING
SCREWS
(#8 x 3/8”
Pan Head)
7 MOUNTING
SCREWS
(#8 X 1-1/2”
Flat Head)
7 DRYWALL
ANCHORS
8 MOUNTING
SCREWS
(#8 x 3/8”
Pan Head)
DECORATIVE FLUE
2 WASHERS
UPPER
FLUE MOUNTING
BRACKET
HOOD
MOUNTING
BRACKET
DAMPER / DUCT
CONNECTOR
4 MOUNTING
SCREWS
(M4 X 30mm
Flat Head)
4 DECORATIVE
WASHERS
NON-DUCT COMPONENTS
GLASS
CANOPY
HOOD
HOUSING
LOWER
FLUE MOUNTING
BRACKET
2 BULBS
B10, 120V
40W MAX.
Vue de la page 2
1 2 3 4 5 6 7 8 ... 27 28

Commentaires sur ces manuels

Pas de commentaire