NuTone NS5430SS Manuel d'utilisation et d'entretien télécharger pdf (Page 8)

NS54000 SERIES

Page 8

INSTALL THE HOOD

(Non-Ducted Hoods Only)

1. CAUTION: Use only expandable aluminum duct provided.

2. Do not remove the protective plastic film covering the decorative

flue at this time.

3. Lay the back side of the hood flat on a table. Use a piece of

cardboard to avoid damaging the table or the hood.

4. Attach damper / duct connector to top of hood using (4)

#8 x 3/8” Pan Head mounting screws.

5. Remove damper flaps from damper / duct connector and

discard flaps.

6. Remove the grease filter by pulling down the metal latch

tab and tilting filter downward to remove.

7. Attach non-duct collar to non-duct plenum using (4) #8 x

3/8” pan head screws.

8. Measure distance “A”. Cut a length of flexible metal duct

(extended) to this dimension.

9. Attach aluminum flexible duct to the damper / duct connector

with a tie wrap.

10. Attach flexible duct to non-duct plenum collar and secure

with tie wrap. Tape all joints with duct tape.

11. Rem ove protective plastic film covering the lower flue only.

12. Carefully place both flues into the recessed area of hood

top.

13. At tac h non-duct plenum with collar to upper flue using (4)

#8 x 3/8” pan head screws.

14. Hold hood up close to wall mounting location and plug

power cord i

nto wall outlet.

15. Align the hood and center it above the hood mounting

bracket. Gently lower the hood until it securely engages the

bracket.

16. If a framing member is not present: With the hood hanging

in place, drill through both holes located in the inside lower

back of hood using a

⁄16” drill bit. Insert the included

drywall anchors into the drilled holes (one for each hole).

17. Install (2) washers and (2) #8 x 1-1/2” mounting screws

through the back of the hood and into the drywall anchors.

Verify that the hood is centered and leveled. Tighten all

screws completely.

NON-DUCT PLENUM

6” ALUMINUM

FLEX DUCT

DAMPER / DUCT

CONNECTOR

4-7/8”

NON-DUCT COLLAR

18. Slide up the upper flue until it is aligned with its mounting

bracket. The bracket should be inside the flue. Secure the

upper flue on the upper flue mounting bracket using (2) #8 x

3/8” mounting screws.

19. Rem ove protective plastic film covering the flue and the

hood.

20. Mount the glass plate on the top of hood base with (4) flat

head screws (M4 x 30mm) and (4) decorative washers.

Screw from top of hood base. Do not overtighten these

screws.

21. Install (2) type B10, 120V, 40W max. candelabra incandescent

bulbs (included).

HOLE LOCATIONS

Ø5/16” TYP.

MOTOR/BLOWER

ASSEMBLY

SIDE VIEW

INSIDE BACK

OF THE HOOD

UPPER

FLUE

UPPER FLUE

MOUNTING BRACKET

FRONT VIEW

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

NuTone NS5430SS Manuel d'utilisation et d'entretien Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine NuTone NS5430SS