NuTone WS1 Manuel d'utilisateur télécharger pdf (Page 3)

Page 3

ALLURE™ WS1 SERIES

RANGE HOOD

PREPARE THE HOOD PREPARE THE HOOD

3 Remove

Damper/Duct

Connector from

inside the hood.

Set connec-

tor aside - with

mounting screws

and parts bag.

4 Remove Wir-

ing Cover from

inside the hood.

Set cover and

mounting screw

aside.

5 Remove either

top or back wir-

ing knockout and

install approved

Electrical Cable

Clamp.

DAMPER/DUCT

CONNECTOR

WIRING

COVER

ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to “Connect

Wiring” section.

6 Remove Light Panel - held in place with (3) #8 screws

and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

(3) #8 SCREWS

LIGHT

PANEL

(2) #8 SCREWS

The following

Steps (6 thru

13) are for

DUCTED

INSTALLATION

ONLY.

BAFFLE

7 Remove Air

Chute - held in

place with one

(1) screw.

NOTE: Be care-

ful not to discon-

nect any wires.

9 Rotate baffle. Re-

insert baffle into air

chute (as shown) so

that baffle tabs fit all

the way into slots in

air chute. An audible

“click” will be heard

when fully installed.

This will close off

the air flow through

the non-ducted slots

on top of hood.

Re-install air chute, re-connect wire

harness, and replace light panel.

NOTE: Be careful not to trap wires

between support fin and light panel.

AIR CHUTE

SLOTS

8 Remove Baffle

from air chute.

BAFFLE

SUPPORT FIN

TABS



1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

NuTone WS1 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine NuTone WS1